Click on any of the images below to see the previous episodes
0
We are almost ready to “Fire her up” just waiting on some computer controls
Day 22
Day 21
0
All right, we are putting back in the motor. more reassembly and we are back on all four wheels.
0
Here are a couple more clips of the rewiring and reassembly. Notice the rear suspension is back in.
Day 20
Day 19
Day 18
Day 17
0
0
0
0
We have the dash in and doing more wiring and suspension, some of the rear as well.
We are putting in the pedals, wiring for the dash and staring on the front suspension.
.We are out of the Booth and its our 1st clip in the reassembly. It’s really taken apart so we will do a bunch of videos during the reassembly
Its In the booth getting painted. Piece by piece making sure all the edges are as nice as the exterior.
Day 16
Day 15
Day 14
Day 13
0
0
0
0
It’s off the bench and on to the paint department. Check it out as it gets body worked, blocked, and primed.
We are getting the seam sealing done and working on the cosmetics. Still have the roll bar to repair. and then the rear engine lid can be mounted.
We are getting all the welding finished up and the exterior body panels on. We have the fenders doors and quarter panels all back on.
Leif Rolls the Ferrari on its side for more precise welding
Day 12
Day 11
Day 10
Day 9
0
0
0
0
Leif Finishes the machining of the plugs that are used to reinforce the joints to be welded.
Leif and John continue pulling the Ferrari and cut the center tunnel to match the cuts made on the donor piece. (3:53)
Leif removes the A-pillar from the Ferrari and trims the donor piece. (3:27)
Leif and John remove the rear bulkhead and pull the Ferrari to remove a kink in one of the rear cross members . (3:15)
Day 8
Day 7
Day 6
Day 5
0
0
0
0
Leif and John remove the pedal assembly from the Ferrari, the lines running down the center tunnel, and the left radiator. (2:32)
Leif takes the donor piece from another Ferrari to Media Blasters. There, the piece is cleaned using ground up walnuts shot from a high pressure hose. (2:41)
Leif and John remove the top from the Ferrari, the second gas tank, and work on the harness. (3:52)
Leif and John clear the center tunnel, remove the gas tank, and continue the pull.
Day 4
Day 3
Day 2
Day 1
0
0
0
0
Watched by students from Springdale JCC, Leif and John from Car Bench start to pull the Ferrari into shape.(2:48)
Leif and the guys from Car Bench put the Ferrari on the rack. Then, Leif removes the front bumper and the dash. (5:19)
Watch as Leif takes the engine out of the Ferrari. (4:27)
Watch as Leif starts the process of tearing the Ferrari apart and assessing the damage. (5:05)
